In wurzburg the overlap route will clear after 30 seconds or something. And setting a shunt route is no problem at all.

But the overlap will not clear automatically in karlsruhe, and i can´t set a shunt route from the signal the train stoped at, not even if i clear the overlap maunally.

Am i doing some wrong or is it a bug in the simulation?

It has been a long time since I simmed Karlsruhe, so today I wanted to, but found it wasn't installed on my PC at this moment (I probably uninstalled it at some point and have forgotten why). I looked in my archives and found the installation file and installed it again (as administrator).

But I can not start the sim!

I can double click on the desktop icon, the clue circle will spin for a few seconds, then nothing. These days I am simming many other Signalsoft stellwerks. They all work, but not Karlsruhe.

I have tried to download and install the DEMO version of Karlsruhe, and that works. I also tried to redownload and install the Pay version of Karlsruhe from my downloads in the shop. But I can't start it.

Approx 1030hrs Lok 2372so shows in the Train Overview Window ready to go to Stw 6. I set the route to Track 186 but the loco does not move. After a period of about 10 minutes I ask why the loco isn't moving, to be told "I am just operating my train". I wonder if Lok 2372so is blocked in by the unstaffed Lok 2261so so I returned Sperrsig 191 to Danger as I needed to run other trains. Lok 2372so then called up after a few minutes telling me he was standing at a red signal! I cleared the signal again but still no movement.

Lok 2261so duly appeared in the Train Overview window at around 1115 so I set a route to Stw 6 Track 165 but this locomotive also does not move.

Neither locomotive moves with Sperrsig 191 cleared. Is this a bug or have I missed something? As always, I appreciate any assistance.

Regards,

Phil.

I am running the sim with the update to Version 3.6.1.6 and I've been running the timetable from 0001hrs Sunday 05/07/15, and until around 0900 everything has worked as planned. However, I just tried to make a shunt move from Track 167 to Track 471/916/906 and found that signal 136I would not clear, either as part of a super route or on its own. I had to authorise the movement to pass signal 136I. I then set routes to 907 and 905 but each time 136I would not clear. 136I does clear with a route set to Track 134. I've read through the Wiki notes again to see if there is something I may have missed (eg special conditions required when setting routes to these tracks) but didn't find anything. Have I missed something? Any help would be much appreciated.

Many thanks.

Regards, 

Phil.