diesel line for Bad Neuenahr

[intallonabile]

Please is there someone that can tell me something about this line. I noticed that after sending a train toward Bad Bodendorf after max 2 minutes it leave Remagen station is possible to set anoother route (from signal N005 to 955) and to clear signal . I must suppose that there is at minimum an intermediate block signal in section Remagen - Bad Neuenahr. But Bad Bodendorf and Heimersheim are stations with a lot of track or only signal block locations ? Is there someone that know the signalling situation between Remagen and Bad Neuenahr on both tracks

Thanks for the reply

Diego

[signalsoftRC]

there are two blocks from Remagen to Bad Neuenahr. The line in between is a double line track with platforms (only) at Bad Bodendorf and Heimersheim.

Plain and straight forward.

note: if the interlocking allows a route and the signal clears, it's safe :-)

You can note a block becoming available if you see the blue locking light at the end button going off. A bell will ring.

[intallonabile]

there are two blocks from Remagen to Bad Neuenahr. The line in between is a double line track with platforms (only) at Bad Bodendorf and Heimersheim.

Plain and straight forward.

note: if the interlocking allows a route and the signal clears, it's safe :-)

You can note a block becoming available if you see the blue locking light at the end button going off. A bell will ring.

Hello Richard.

As you i'm sure that a clear signal indicate always a "good" block section !!!

dIEGO

[intallonabile]

Hello Richard.

As you i'm sure that a clear signal indicate always a "good" block section !!!

dIEGO

As i'm here i have a final question. In setting options when simulation starts is possible to choose to have a confirm if switches (points) moving (or not) when i set a route but this bell ring is not present in simulation in both options. The same when i set the route from track 005 to 955 at Remagen and The blue circle was light (on) but bell doesnt ring.

Thanks for the reply

Diego