Urmitz problems

[intallonabile]

it seems there are some problems in Urmitz. Signal 1F, R401 R410 and 1A and 1AA dont have an aspect for Vorsignale (for any aspect of next signal) . I set a route from R401 to N502 and now when i try to revoke the route signal box doesnt make the deletion

Good Evening

Diego

[signalsoftRC]

if the little indicator at the bottom of the signal is DARK, it's showing Vr 0, if the signal is clear. It's only green if the distant signal aspect is showing "green" = Vr 1. It's just not shown on the panel.

R401 to N502 normally runs in and deletes. If you can't delete it, note that you might need combinations of FRT or FHT to revoke the route or the route parts. As you can't see on the panel the difference of a train or shunt route. And remember that a train route is build up from a shunt route.

[intallonabile]

thanks for your reply to my question

Diego

[intallonabile]

Richard please, i'm alone from my PC and so i can't immediately verify so to well understand your reply .

please can you repeat me in wich case the two little point for vorsignale (on the main signal) plate are light

thanks for your patience toward me

Diego

[TjoeTjoe]

please can you repeat me in wich case the two little point for vorsignale (on the main signal) plate are light

Diego,

the distant signals for those signals you mentionned do not have a visual indication on the panel !! That's what Richard is saying

I understand Richard words as follows:

- main signal at Stop, distant signal at Dark

- main signal at Proceed, and next main signal at Stop, then distant shows Vr0 -> yellow indication not shown on panel

- main signal at Proceed, and next main signal at Proceed then distant shows Vr1 (double green) -> no distant indication on panel (it only has two lights, maybe for saving money ;-) )

So in short the small Vorsignale signs do not show statusses here for Vr0 Vr1 / Vr2

Erwin

Edited November 28, 2012 by TjoeTjoe
Corrected as per response by Chef Ep

[intallonabile]

OK. thanks Erwin

i well comprise

Good evening

[signalsoftRC]

Erwin: it's the other way around. if there are only "two holes" for the distant signal (like in Urmitz) only the Vr 1/2 indication is shown (green lights). If it's Vr 0, it's not shown on the panel, though it might be lit up outside.