Bonn-Duisdorf

[littlepe]

Hi. I have a train (11606) that has left Bonn for Duisdorf but i cannot get it past sig p203. I have used the ZNP801 and the train has been accepted and its no. is steady on the board alongside the exit track 250. I have repeatedly clicked on the sig 203 button and the end button near 250 but cannot get the route to set. Please - any advice?

[Danielm]

Hi littlepe.

To set a route to a non-electrified track you may press the "FfrT" first.

Set Route To Track Without OLE Button (Wiki)

regards

Daniel

[TjoeTjoe]

Daniel's Tip is spot on.

I have updated the Dispatching In Bonn Wiki page on this as well.

Though a hint was already hidden in the text, it is just something one easily forgets.

Furthermore, I can only recommend to enable the feedback indications shown on the bottom right of the sim when playing it for the first time.

There, some feedback is given on why certain actions are not accepted by the system

Erwin

[littlepe]

Many thanks chaps - i missed that one. There sure is a lot to learn but i must say i am really enjoying doing so - an enthralling sim. Was this the hint 'The line to Bonn-Duisdorf doesn’t have Overhead Line Equipment, so don’t think of sending something there that doesn’t have pantographs.' ? Should it say 'does have pantographs'?

Once again many thanks for prompt response - the support for this sim is excellent and appreciated.

regards

[TjoeTjoe]

Should it say 'does have pantographs'?

Yes, it should say that, and does say that now. Funny typo which was existing from day 1 in the PDF manual as well as in the Wiki. Thanks for the heads up

Erwin