Unable To Revoke Routes

[pblanksb]

Whilst trying to familiarise myself with the Dusseldorf-Gerresheim panel I have attempted to set and revoke various routes but I cannot revoke any routes. I have read the Wiki pages for Dusseldorf-Gerresheim and for Sp Dr S 600 panel group buttons and followed their instructions, but I am still unable to revoke any routes, despite trying various button combinations. Is there something I have overlooked, and has anyone else encountered this problem?

Any help would be appreciated.

Regards,

Phil.

[Helmut]

Hi Phil,

before you can revoke a route with SpDrS 600 you have to set the start signal to red by using the HaGT. Did you do this?

Regards

Helmut

[pblanksb]

Hi Helmut,

Yes I have set the signals to red but I still cannot revoke the routes, and I also cannot get the signals to show proceed again.

Regards,

Phil.

[Gleissperre]

What did you do?

Example:

• Set the route N103 - 303 by pressing the two signal buttons.
• Wait until N103 shows proceed.
• Press HaGT and N103. Signal falls back to stop.
• Remove the blue cap from FHT G.
• Press FHT G and the button of signal 303 (destination). Route will revoke.

[pblanksb]

After having another look at the Wiki pages I've realised my error.

I was replacing the signals to red, but then trying to revoke the routes in the same way as on a Sp Dr S 60 panel by pressing the start and end buttons of the route, when I should only press the end button. Problem solved.

Regards,

Phil.

[Helmut]

Hi Phil,

after setting the start signal to red you have to use the FHGT only with the end button of the route.

I`'ve just tried myself, it should work.

Regards

Helmut

[pblanksb]

Hi Helmut,

Yes I had overlooked that instruction, just the end button, not start and end as on the Sp Dr S 60 panel. I've tried it myself now and it works.

Thanks for your help.

Regards,

Phil.