Very thanks to Signalsoft team (official and all developers) for this new simulation

 

please is there someone that can tell me how to introduce coordinates to set routes ?

 

i must indicate signal as A805 or N001 or only numeric 805.001. I have tried but ???  always appears and no routes are set on screen.

 

thanks in advance for reply

 

Diego from Italy

Hi,

 

In your case it should be A805.N1 But this route should be set automaticly, so no need to set this route.

The only routes you'll have to set is routes to/from Landgraaf or routes to/from Eschweiler:

 

From Eschweiler: G890.yyy (replace yyy with proper track)

To Eschweiler: F,yyy.890II  (replace yyy with proper track)

From Landgraaf: H870.yyy (replace yyy with proper track)

To Landgraaf: F,yyy.870II  (replace yyy with proper track)

 

Example: train from Landgraaf to platform 2 Herzogenrath: H870.P2

              train to Landgraaf from platform 1 Herzogenrath: F,N1.870II

 

Please take a look at wiki how to operate the control monitor (DET): https://railsignalling.org/signalwiki/index.php?title=Control_Monitor_Sp_Dr_S_600

 

Greetings,

 

Peter

Amsterdam

ok thanks.

for example

entrance from  Alsdorf in track 001

I set on the first space after EIN  :     G890.055

 

Then when i press Enter or VL there are ??? flashing at the end of the command line  and no route is set

 

Is there something wrong in my  way ?

 

Hi,

 

just omit any leading zeros, so for the above example enter G890.55

 

This should work.

 

Regards,

 

Christian

Hi,

 

That should be G890.55I

 

If you move your mouse to the signal it will say its number. In this case 55I.

 

Greetings,

 

Peter

Thanks Peter. For the first time i have fixed a route !!!

 

Alleluia

 

 

 

Nice!

 i think that without a specified file with indication of entrance and final command for each route Data entry Screen is too complex to use.

 For example a route toward Geilenkirchen  start signal to 9011   but if i write this on Data entruy screen i have only an error message.

Diego

In the German wiki it is all mentioned in section 1.5 "Abweichende S600 Befehle". This section seems to be missing in the english wiki. In this section it is also mentioned, that there is a hint in the title bar of the window (N055 (N55)).

Thanks for the reply. Unfortunately i only speak English.

Now  i set all entrance and exit routes. Then i revoke them with Hagt+Fhgt and so i can see on Data entry screen the exact name of each point so to use this for creating routes. It is a more complex but result is ok.

 

Hi Diego,

 

I have added a little table with common train routes for Herzogenrath on the Englisch Wiki page.
Hope this helps you.

I might also talk to the developers to put those commands into the DET as a default for the simulation.
You're not alone when it comes to struggling with the DET system

Very thanks to you, my friend.

 

Have a good evening

 

Diego